Arduino® Uno WiFi Rev2

The Arduino UNO WiFi Rev.2 is the easiest point of entry to basic IoT with the standard form factor of the UNO family. Whether you are looking at building a sensor network connected to your office or home router, or if you want to create a Bluetooth Low Energy device sending data to a cellphone, the Arduino UNO WiFi Rev.2 is your one-stop-solution for many of the basic IoT application scenarios.

Add this board to a device and you'll be able to connect it to a WiFi network, using its secure ECC608 crypto chip accelerator. The Arduino Uno WiFi is functionally the same as the Arduino Uno Rev3, but with the addition of WiFi / Bluetooth and some other enhancements. It incorporates the brand new ATmega4809 8-bit microcontroller from Microchip and has an onboard IMU (Inertial Measurement Unit) LSM6DS3TR.

The Wi-Fi Module is a self-contained SoC with integrated TCP/IP protocol stack that can provide access to a Wi-Fi network, or act as an access point. It is the u-blox NINA-W102 and (here) you find the datasheet.

The Arduino UNO WiFi Rev.2 has 14 digital input/output pins-5 can be used as PWM outputs-6 analog inputs, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller. Simply connect it to a computer with a USB cable or power it with an AC adapter or battery to get started.

Technical specifications:

Microcontroller: ATmega4809 (datasheet)
Operating Voltage: 5V
Input Voltage (recommended): 6 - 20V
Digital I/O Pins: 14 - 5 Provide PWM Output
PWM Digital I/O Pins: 5
Analog Input Pins: 6
DC Current per I/O Pin: 20 mA
DC Current for 3.3V Pin: 50 mA
Flash Memory: 48 KB (ATmega4809)
SRAM: 6,144 Bytes (ATmega4809)
EEPROM: 256 Bytes (ATmega4809)
Clock Speed: 16 MHz
Radio module: u-blox NINA-W102 (datasheet)
Secure Element: ATECC608A (datasheet)
Inertial Measurement Unit: LSM6DS3TR (datasheet)
LED_BUILTIN: 25
Length: 68.6 mm
Width: 53.4 mm
Weight: 25 g